Overview: 14-Inch Celestron
This quick guide is intended as a reference for users who are already familiar with the telescope's operation. You are responsible for following all warnings and instructions described in the full manual.
Major Warnings
- Don't move the telescope by hand. Moving manually invalidates the mount's coordinate solution, which will not only make it hard to find objects in the sky, but can make the mount attempt dangerous slews.
- Always have the keypad's STOP button, or software equivalent, within reach while the telescope is slewing. Keep in mind that Starry Night tends to freeze during a Park command – you can't rely on a software stop then, but the keypad will still work.
- If you find that one of the eyepieces is dirty, please don't try to clean it yourself. Let us know and we'll take care of it.
- Do not use the Star-Sync command unless the mount's slewing is badly out of whack and you know what you're doing, and never use it within an hour of the meridian. In normal use, use the less invasive Re-Calibrate.
- Do not point this telescope at the Sun unless you have been trained and authorized with the solar filter – the telescope will focus the sunlight intensely enough to cause blindness and burns. Even observing by projection is unsafe.
Quick Start – Computer
Move the cart first
Roll out the scope
Lift over the threshold
Park the scope here
Start with this screw...
... then this one...
... and this one last.
Plug in the power supply
Plug in the control cable
Plug in the power
Put in an eyepiece
Power up the mount
Telescope tab
Click Connect
Slew to a star
Center Starry Night
Sync gaze
Shutdown – Computer
Park when finished
Wait until the scope stops
Close the connection
Unplug telescope
Unlock the mount
Roll the scope back inside
Quick Start – Keypad Only
Counterweights MUST face north to clear cart
Lift over the threshold
Park the scope here
Start with this screw...
... then this one...
... and this one last.
Plug in the power supply
Plug in the power
Put in an eyepiece
Power up the mount
Location = 1
Resume from Park
Check DST
Slew to a star
Center carefully
Re-calibrate
Shutdown – Keypad Only
Park 3 when finished
Wait until the scope stops
Unplug telescope
Unlock the mount
Roll the scope back inside